🪢 Automatic coil binding
Large coils leave the machine already bound.
Samec RV800EL coils thicker flexible cables and tubes into large coils and binds them automatically (elastic tie). The coil is formed on a rotating pin plate under a Plexiglas guard. When finished, the guard lifts by itself and the pins retract into the plate. The operator removes the coil and presses the pedal: first the guard closes, then coiling starts. The machine stands on self-braking swivel castors, and operating modes are set on a touchscreen.
Pin plate and cable being coiled
Tie reel for automatic coil binding
Large cable coil bound by the coiler
Beckhoff touchscreen for setting operating modes
Large coils leave the machine already bound.
Inner diameter from 208 mm, outer up to 713 mm, cables Ø 10–30 mm.
After the cycle the coil is easy to remove, and the pedal closes the guard and starts coiling.
Connector for Samec machines; with an encoder and sensor, it also works with other manufacturers' machines.
| Cable diameter | Ø 10–30 mm |
|---|---|
| Coiling diameter | min. 208 mm (inner) – max. 713 mm (outer); the datasheet also gives 365 mm |
| Coil inner diameter | min. 208 mm |
| Coil outer diameter | max. 713 mm |
| Coiling speed | 2.5 m/s (adjustable) |
| Coiled piece length | Depends on cable diameter |
| Electrical supply | 400 V – 50/60 Hz, max. 0.75 kW |
| Pneumatic supply | 6 bar, continuous operation |
| Dimensions and weight | 2262 × 1506 × H 2474 mm • 480 kg |
| Manufacturer's note | Data may vary depending on cable stiffness |
When you coil thicker cables (Ø 10–30 mm) into large coils and want them to leave the line already bound. Without binding, a similar coil range (up to Ø 750 mm) is covered by the RV800, and smaller coils with binding by the RV500EL.
Flexible cables and tubes 10–30 mm in diameter, into coils with an inner diameter from 208 mm and an outer diameter up to 713 mm. The manufacturer notes that the data depend on cable stiffness.
The RV800EL binds coils automatically and is designed for thicker cables (from Ø 10 mm). It requires a 400 V supply.
The operator removes the coil and presses the foot pedal: first the guard closes, then coiling starts.