🔌 All IDC combinations
IDC-IDC (basic version), IDC + crimped terminal, crossed wires, Zeta and Jump cables.
Wirmec IDC Hybrid is an automatic line for processing IDC (insulation displacement) connectors. It handles all common combinations: IDC-IDC in the basic version, as well as IDC with a crimped terminal on the other end, crossed wires, and Zeta and Jump cables. Polarisation is programmed in the interface, and quality control checks the wire position in the connector against the connector manufacturer's tolerances. Wirmec agrees configuration details individually, under confidentiality.
Example harnesses with IDC connectors
IDC-IDC (basic version), IDC + crimped terminal, crossed wires, Zeta and Jump cables.
5 wires on the hybrid side and 20 wires on the IDC-IDC side, 3 presses.
Verification of wire position in the connector against the connector manufacturer's tolerances.
Polarisation programmed in the interface, cycle time approx. 0.4 s per pin.
| Wire feeder | 5 wires (hybrid side) • 20 wires (IDC-IDC side) |
|---|---|
| Number of presses | 3 |
| Number of pins | 20 side A + 20 side B, 2.5 mm pitch |
| Wire length | 110–3000 mm |
| Wire outer diameter | Ø 1.1–1.5 mm |
| Polarisation | Programmed in the interface |
| Quality control | Wire position in the connector per the connector manufacturer's tolerances |
| Cycle time | approx. 0.4 s per pin |
When you mass-produce harnesses with 2.5 mm pitch IDC connectors (e.g. household appliances, electronics), including mixed ones – with IDC on one end and a crimped terminal on the other. Harnesses with crimped terminals only are handled by AM machines.
IDC-IDC, IDC with a crimped terminal, crossed wires, and Zeta and Jump cables, with 2.5 mm pitch, up to 20 + 20 pins.
Wires with an outer diameter of 1.1–1.5 mm, length 110–3000 mm.
The cycle time is approx. 0.4 s per pin.