🎯 Large tools up to 35 mm
Inner diameter measurement of large dies and wire guides: maximum, minimum and average values.
VisioCablePro® VCPEx+ Stand is a stand-alone camera station for fast, accurate measurement of large wire guides and extrusion dies with bores up to 35 mm. It measures the maximum, minimum and average inner diameter of the tool, so you can detect deformation or wear before it causes insulation walls that are too thick or too thin. Measurement is automated, and uniform LUMIMAX® backlighting from below plus a focus indicator keep operator influence to a minimum. It complements the dual-camera VCPEx+ for tools larger than 15 mm.
Tool on the measuring table with LUMIMAX® backlighting from below
Inner diameter measurement of large dies and wire guides: maximum, minimum and average values.
An automated measuring sequence replaces callipers and contact measurement, and operator influence is reduced to a minimum.
Uniform transmitted light from below and a focus indicator make setup easier, resolution 0.1% of the image field.
Results are saved, so you can see how each tool wears over time. For production, the tool store and the lab.
| Product number | 401.0007.07 |
|---|---|
| Dimensions (W × L × H) | 400 × 460 × 630 mm |
| Weight | 15 kg |
| Power supply | 100–240 V, 50–60 Hz |
| Power | max. 100 W |
| Resolution | 0.1% of the image field |
| Lighting | Uniform, LUMIMAX® |
| Camera | 1 measuring field, configurable |
| Measuring range | up to 35 mm bore diameter |
| Measurement results | Inner diameter: maximum, minimum and average |
The VCPEx+ (401.0007.04) measures tools up to 15 mm on two measuring fields in a closed housing. The VCPEx+ Stand (401.0007.07) is intended for large dies and guides with bores up to 35 mm, typical in extrusion of power cables and thicker jackets. The manufacturer designs it as a complement to the VCPEx+, so together they cover the full range of extruder tooling. You can then check the effect of tool wear by measuring the cable on the VCPX5 or AlphaOne.
Large wire guides and extrusion dies with bore diameters up to 35 mm. The result is the maximum, minimum and average inner diameter.
The VCPEx+ measures tools up to 15 mm on one or two measuring fields. The VCPEx+ Stand has one configurable measuring field and measures large tools up to 35 mm. The manufacturer designs it as a complement to the VCPEx+.
In production, at the tool store and in the lab – wherever the condition of large dies and guides needs to be checked before extrusion.